EDU1FR Series Controller

CONTROL UNITS

All the FAB, RAF series screwdrivers work in combination with a control unit acting as an AC to DC transformer and torque controller. The electronic control circuit cuts the power supply to the motor as soon as the pre-set torque has been reached.

The new EDU1FR control units for FAB and RAF screwdrivers feature a maintenance free state-of-the-art electronics with no wearing components with a circuit design suitable to both lever start and push start drivers with protection against current overload up to 10A. This design results in very low current to the drivers start switch and clutch switch to extend their life indefinitely.

Additional features:

• Suitable to universal supply from 90 to 260 V ac 50/60 hz.
• Slow start (0-2 seconds) and RPM (60% to 100%).
• Visual indicators (green“red) for power on/off and clutch action.
• Reduced weight (1.33 lbs) and compact size for easy placement.
• New M12 waterproof connector with silver and gold contacts for perfect conductivity.

The new EDU1FR/SG controller features additional circuits wired to 2 connectors in the back panel: one connector sends out 24V signals for torque reached and lever (motor running), the second connector is designed to accept remote start and remote reverse signals.

A double output connector (DOCK01) is also available for operators using two screwdrivers on the same working area. One end of this device is to be connected to the controller (cable included), the other end to the drivers. The screwdrivers are not to be used at the same time.