Electric Screwdrivers and more!

Smart-Arm P/N: PS2E-0750-0001

The Smart-Arm system error-proofs your assembly process by enabling the screwdriver to operate only when it is at the correct location, sequence step (optional), and that the appropriate torque program is used at each location.  The Smart-Arm is built using bearing guides at the two post pivot points.  The bearings allow for very tight assembly tolerances, this enables programs to be shared across multiple arms using the optional upload/download software tool.  Additional assembly process control can be gained by implementing the optional Pick-to-light sensors "Smart-Bins" and/or a bit tray "Smart-Bits.  A visual aid for the operator is also available by implementing the optional Guided Assembly software which positions a moving cross hair, that represents the centroid of the tool, over a .jpg of the part with a visual target that turns green when the tool is correctly positioned.

The Model PS2E-0750-0001 Smart-Arm is supplied with three (3) encoders for tracking the arm  X & Y position within 2.0 mm.  The Z encoder tracks the arm along its arc as it travels.  Screws as close as 2mm can normally be repeatable located depending on the tooling stack-up.  Positional Tolerance can be adjusted in the operating software from 5 - 15mm.  A Control Box with the encoder cables and standard software is included.  The tool holder, control interface cable, and mounting Pillar must be specified separately based on the specific application.

Arm Design:

• Max Reach: 27.9 inches
• Load Capacity: 0 - 2.2 lbs.
• Max Torque: 30 Nm

Software: Three modes of operation

• Standard: Torque Mode
• Optional: Sequencing Mode
• Optional: PLC Mode with rework control

Memory:

• Standard: 5 recipes with 40 points per recipe
• Optional memory upgrade: User defined, max of 512 recipes with 20 points or 138 recipes with 100 points

Programming:

• Standard: Manual position to position programming with jog dial
• Optional: Upload/Download tool to share programs between arms
• Optional: Guided Assembly Software.
• Optional: Barcode scanner for recipe selection

Configurable Digital Inputs and Outputs:

• Standard: Maximum of 12 Smart Bins
• Standard: Up to 3, 4 position bit selectors with LED indicator
• Standard: Mix and match bins with bits to error proof process
• Optinal: custom I/O configurations

Tool Configuration: (select one per arm based on the screwdriver being used)

• Kolver
• Atlas Copco
• Micro Torque
• Ingersoll Ran
• Acra
• Stanley
• Others available on request

Note: Pricing is subject to change based on application