Electric Screwdrivers and more!
A Blackstone Global Company
Thread Cutting Controllers
The Parameter Delay Time enables the EDU1AE, PLUTO Screwdriver Controller, to run at it's full torque capacity for a pre-set amount of time, before downshifting to a final tightening profile. This allows the tool to overcome high prevailing torque in a thread cutting application and seat the screw at a lower torque.
The Delay Time Parameter is avalible on the following Controllers:
- EDU1AE/MT
- EDU1AE/LTP/MT
- EDU1AE/C/DT/MT
- EDU1AE/TOP/MT
- EDU1AE/TOP/LTP/MT
The Delay Time feature is only available when purchasing a separate unit (MT) with the standard EDU1AE as a precaution. Because, if the feature is setup incorrectly the tool can cause damage to your part and injure your operator. It is standard on the EDU1AE/TOP after this fall.
EDU1AE/MT: For Thread Cutting |
|
|
|
The EDU1AE/MT: FOR THREAD CUTTING This version 2.2 system allows parameters to be set up to control the torque and RPM profile for one program. The system is set up through a LCD display on the front of the unit. Changes to the parameters are performed by scrolling through the settings using four buttons. |
EDU1AE/LTP/MT: For Thread Cutting |
|
|
|
The EDU1AE/LTP: FOR THREAD CUTTING This system allows parameters to be set up to control the torque and RPM profile for one program. The system is set up through a LCD display on the front of the unit. Changes to the parameters are preformed by scrolling through the settings using four buttons. |
EDU1AE/TOP/MT: For Thread Cutting |
|
|
|
The EDU1AE/TOP/MT-MultiTorque Inspector for Pluto Screwdrivers: This system allows parameters to be set up to control the torque and RPM profile for one program. The system is set up through a LCD display on the front of the unit. Changes to the parameters are preformed by scrolling through the settings using four buttons. |
EDU1AE/TOP/MT/USB |
|
|
|
The EDU1AE/TOP/MT/USB-MultiTorque Inspector for Pluto Screwdrivers: This system allows parameters to be set up to control the torque and RPM profile for one program. The system is set up through a LCD display on the front of the unit. Changes to the parameters are preformed by scrolling through the settings using four buttons. This system stores data automatically on a USB memory stick, when one is plugged into the USB port. This means the amount of data you can store is based on memory limit in the flash drive. |
Recent Blog Posts
Mar 10, 2011
Cutting Edge Ergonomics with KolverUSA’s PLUTO Push to Start Tool
Dec 28, 2010
KolverUSA has Gone Social with Facebook and Twitter
Oct 15, 2010
KolverUSA Turns Heads at the ATExpo
Sep 14, 2010
KolverUSA’s Micro-Tool Screwdrivers-Efficient and Inexpensive
Jun 8, 2010
KolverUSA Releases Their 2010 Catalog
Featured Model
EDU1FR/ACE
EDU1FR/ACE
EDU1FR/ACE
Consists of:
- EDU1FR/SG controller
- ACE Screw Counter
The ACE screw counter is a process control system that monitors the fastening assembly process. It tracks, in real time, the fastening of each screw in an assembly, then notifies the result. It keeps a summary of good and complete assemblies as well as of bad and incomplete ones throughout the production day.